“With just one or two lines of code through Force Copilot, we let the software generate all the part positioning.”
“The big advantage of the force torque sensor is that you can record complex movements with the path-recording function.”
“The whole integration went very smoothly. Half our staff is over 40 years old, and everyone found it easy to learn to work with Robotiq and Universal Robots.”
“I didn’t have programming skills but I found it very easy, with logic knowledge, to program the robot, the 2-Finger Adaptive Gripper and the Wrist Camera.”
“We’ve achieved ROI in less than a year and we’re able to produce the same amount of work in two 8-hour shifts instead of three, before the robot arrived.”
“If there is an issue with the robots, we are able to repair them ourselves and power them back up again. They are really quite easy to handle.”
“We got the UR10 out of the box and were able to get it running, adding the gripper at the end of arm within just a few hours.”
“Our project reject rate has gone from double-digits to below 1% and our overhead is significantly reduced.”
“Whether I’m in the shop or not, Insights signals any stop immediately. I then put the robot back into production faster. Minimum downtime means higher productivity.”
“We’ve increased our production capacity by being able to run the machine during unattended hours. We are now considering the possibility of in-sourcing more work because of our enhanced production capacity.”
“Of course we measure production time, but the setup teaching time is the most crucial aspect of the robot’s performance. If it takes 4 hours to get the robot going between every part, we will not succeed. With our actual robot and gripper, the setup time is short.”
“Everybody was anxious at the beginning. It turned out to be a lot safer and simpler than we thought it would be. We realised that if you can use an IPhone, you can use these robots.”
“The repeatability and the consistency of what’s going on in the machine is a huge plus for us. We make high-end quality products, it is very important to deliver the same standard in every production.”
“I accepted the challenge even though I had no experience in robotics. With the help of the distributors and some training, within a few weeks I was able to understand the basics of the robot and start programming for the end solution of the application.”
You’ve stumbled upon a combination of products & applications for which we have no case study yet.
Want to be featured in our next case study?